Advertisement
E)
DAILY USE INSTRUCTIONS
SELECTING THE THERMOSTAT OPERATING MODE USING MODE BUTTON
The operating mode of the thermostat can be changed by pressing the MODE button. The
available modes are as follows:
·
Auto: The thermostat selects heat or cool as required
!
Reminder - This mode is only available if the building owner or installer has set
the thermostat to allow auto change-over mode
·
Heat: Only heating is operated, cooling is switched off
·
Cool: Only cooling is operated, heating is switched off
·
Off: Both heating and cooling are turned off
!
Caution – there is no freeze protection in "Off" mode
F)
SELECTING THE THERMOSTAT FAN OPERATING MODE USING THE FAN
BUTTON
The operating mode of the thermostat fan can be changed by pressing the FAN button. The
available modes are as follows:
·
Auto: The fan runs whenever there is a demand for either heating or cooling
·
On: The fan runs continuously
·
Smart-fan: If programable fan option has not been enabled the fan runs
continuously between events 1 & 6 (6 events), 1 & 4 events (4 events) or 1 & 2
(2 events) but reverts to Auto between events 6 & 1 (6 events), 4 & 1 events (4
events) or 2 & 1 (2 events). If programable fan option has been enabled, the fan
will follow the program when Smart fan is selected.
G)
TEMPORARY CHANGES TO PROGRAMED TEMPERATURES
∧
G.1. Use
to temporarily raise temperature
∨
G.2. Use
button to temporarily lower temperature
!
Reminder - Limited temperature adjustment: The amount of temperature
adjustment may have been set by the building owner or the installer
!
Reminder - Automatic cancellation of overrides: The factory setting for this is at
the next event, however, the building owner or the installer may have selected a
different option
Note: A flashing override arrow indicates an override timer is active and an event
time has been crossed.
H)
SELECTING HOLD MODE AND VACATION MODE
!
Reminder – This function is not available if the building owner or installer has
locked the keyboard
Hold mode options
H.1. Programs can be permanently overridden by selecting HOLD mode, this feature is
used if fixed temperatures are required for extended periods of operation
H.2. To enter HOLD mode press both
seconds
H. 3. Once in HOLD mode it is possible to select the required heating and cooling
temperatures and the thermostat operating mode, see below for setting details
Selecting the required heating temperature
a) Press MODE button to select HEAT mode then use
heating temperature
Selecting the required cooling temperature
b) Press MODE button to select COOL mode then use
cooling temperature
c) Press MODE button twice again to return to AUTO mode. The thermostat will now
operate heating and cooling to maintain the selected temperatures
!
Reminder - Auto can only be selected if the building owner or installer has set the
thermostat to allow auto changeover mode.
4
∧
∨
and
buttons together and hold down for 2
∧
∨
or
buttons to select required
∧
∨
or
buttons to select required
LCD DISPLAYS
A
UTO
H
EAT
C
OOL
O
FF
Mode select options
Fan Mode Select Options
77
68
69
f
O
Temporary override
of temperature
UTO
76
67
UTO
50
EAT
A
UTO
Hold Mode selecting
heating temperature
80
OOL
A
UTO
Hold Mode selecting
cooling temperature
UTO
80
50
UTO
Hold Mode with Auto heat
and cool selected
BUTTONS
Mode
Fan
∧
∨
or
∧
∨
plus
∧
Mode
then
or
∨
∧
or
Mode
then
∨
X 2
Mode
Advertisement
