Accessing Gemstall - VeriFone GemStall Ruby SuperSystem User Manual

Ruby SuperSystem™

Accessing GemStall

Before accessing GemStall, be sure you have completed the following:
• Installed GemStall software on your laptop.
• Installed the application software on your laptop.
• Placed the Ruby terminal into SysMgr mode (see note below).
• Connected the 9-pin null modem to your laptop.
• Connected an RS232 cable from the null modem (on your laptop) to
comport 1 on the Ruby terminal.
NOTE: GemStall only works when the Ruby terminal is in SysMgr mode. To
access SysMgr, take a small-tipped pen or paperclip, press and hold the
button closest to you on the right-hand side of the terminal until you hear the
Ruby beep. At this time the Ruby will power down and come back up. You
know you are in SysMgr when, "Select a YES key NO double-wide keys" is
displayed on the terminal. You don't need to press any keys on the Ruby at
this time.
To Access GemStall:
STEP ACTION
1 Open your MS-Dos Prompt. *
2 At the C prompt type the following:
cd\gemstall
then press the <ENTER> key.
3 You should now see the following:
c:\gemstall
If you receive a message indicating no directory found you have
not installed GemStall or have installed the program incorrectly.
4 At the c:\gemstall prompt, type the following:
Gemstall
Then press the <ENTER> key.
If you receive an error message indicating no file found you have
not installed GemStall or have installed the program incorrectly.
* If you are using Windows 2000 or ME, your MS-Dos prompt can be found
by clicking on Start, Programs, and then Accessories.
VeriFone Confidential 4
GemStall
9/4/02