Intel IoT Gateway Development KitDK200 Series Getting Started Manual page 41

Put Intelligent Device Platform XT Runtime Image onto USB Flash Drive—Intel IoT Gateway
Development Kit DK200 Series
accidentally include the partition in the command, you will receive an error
message:
e.g.: /dev/sdb
Warning: The following command will overwrite all contents on your USB flash
2. In the
USB flash drive with two partitions and deploy the
This command also changes the media name on the USB flash drive. Choose the
appropriate command for your circumstances, replacing the ? in sd? with the
information you wrote down in the previous step:
sudo ./deploy.sh \
-u -f export/intel-quark-glibc-idp-standard-dist-srm.tar.bz2 \
-d /dev/sd? -y -b clanton-hill
3. Type your password at the prompt:
You may see an error screen stating it is not possible to open the folder
wr_usb_boot, as shown below. This is not a concern. If you receive this message,
click OK.
Figure 21. Folder Error for wr_usb_boot
April 2015
Order No.: 330295-004
ERROR: Device mode should be set to -d option.
drive. The USB flash drive must have a capacity of at least 4 GB.
directory, type the following command to format the
$HOME/projects
file to the USB flash drive.
tar
[sudo] password for <username>
®
Intel IoT Gateway Development Kit DK200 Series
.
Getting Started Guide
41