Table of Contents
Advertisement
Understanding the printer menus
Use
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300 sec
Timeouts
Print Timeout
Disabled
1–255 sec
Timeouts
Wait Timeout
Disabled
15–65535 sec
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Max Auto Reboots
1–20
Print Recovery
Auto Continue
Disabled
5–255 sec
To
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds the printer waits before the it
returns to a ready state.
Note: 30 sec is the factory default setting.
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
•
90 sec is the factory default setting.
•
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Note: 40 sec is the factory default setting.
Set the printer to restart when an error is encountered.
Notes:
•
Reboot always is the factory default setting for Auto Reboot.
•
2 is the factory default setting for Max Auto Reboots.
•
If the printer performs the same number of automatic
reboots that is set in the printer within a certain amount of
time, then the printer shows the applicable error instead of
rebooting.
Let the printer automatically continue printing from certain offline
situations when these are not resolved within the specified time
period.
Note: Disabled is the factory default setting.
70
Advertisement
Table of Contents
