Controls & Features; Deck Height Index; Deck Lift Handle; Cup Holder - Troy-Bilt Pivot S Operator's Manual

Controls & Features
Brake Pedal
Steering Wheel
Fuel Tank Cap
Transmission Bypass Valves
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.

Deck Height Index

The deck height index consists of eight
index notches located on the front/right
of the console. Each notch corresponds to
a 1⁄2" change in the deck height position
ranging from 1-1⁄2" at the lowest notch to
4" at the highest notch.

Deck Lift Handle

The deck lift handle is located on the front/
right of the console, and is used to raise and
lower the mower deck.
Pull the handle to the left out of the index
notch and push downward to lower the
deck, or pull upward to raise the deck.
When the desired height is attained, move
the lift handle to the right until fully in the
index notch.
Forward Drive Pedal
Reverse Drive Pedal
Parking Brake/Cruise Control Lever
Deck Lift Handle
Deck Height Index
Throttle/Choke Control
LCD Service Minder & Hour Meter
PTO Knob
Ignition Switch
Module

Cup Holder

Storage Tray
Transmission Bypass Valves
Cup Holder
The cup holder is located on the RH console to the right of the
operator's seat.
Storage Tray
The storage tray is located at the rear of the RH console.
Seat Clamp Knob (Not Seen)
The seat clamp knob is located below the front/left of the seat.
The knob allows for adjustment forward or backward of the
operator's seat. Refer to the Assembly & Set-Up section for
instructions on adjusting the seat position.
4
13