CITROEN DS3 Handbook page 213

F Position the foot of the jack 2 on the ground
and ensure that it is directly below the
front A or rear B jacking point provided on
the underbody, whichever is closest to the
wheel to be changed.
on vehicles fitted with sill finishers, the
jacking location is indicated by a marking
on the finisher. The jack must be placed
centrally in line with this marking, at the
jacking point located behind the finisher
and not on the plastic finisher itself.
F Extend the jack 2 until its head comes into
contact with the jacking point A or B used.
The contact surface A or B on the vehicle
must be engaged with the central part of
the head of the jack.
F Raise the vehicle until there is sufficient
space between the wheel and the ground
so that the spare (not punctured) wheel can
then be fitted without difficulty.
Practical information
F Remove the bolts and store them in a clean
place.
F Remove the wheel.
211