Advertisement
Quick Links
~. Temperature control
2. Defrost drain tube
(on models CA15D. CA15E)
3. Rating plate–record
model and serial numbers
here for future reference.
Model #
Serial #
71
Do not remove rating plate,
-.
IMPORTANT: PLEASE READ CAREFULLY
1. FOR PERSONAL
SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a three-prong
(grounding)
plug which mates
ceptacle
(Fig'. 1) to
minimize the possibil-
ity of electric
shock
hazard from this appli-
ance. Have the wall
receptacle checked by
a qualified electrician
to make sure the re-
eptacle is properly
rounded.
11.6
to
ViM3
cubic
feet
with a standard three-prong (grounding) wall re-
PREFERREDMETHOD
n ,
(--$
Q . i
'%7
~1
.f?h\
INSURE PROPER
GROUND EXISTS
BEFOREUSE
– Where a standard two-prong wall receptacle is en-
countered, it is the personal responsibility and obli-
gation of the customer to have it replaced with a
properly grounded three-prong wall receptacle.
DO NOT
LJAIDERANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM
THE POWER CORD.
USAGE OF ADAPTERPLUG
Because of potential safety hazards under certain
conditions, we strongly recommend against the use
of an adapter~plug. However, if you still elect to use
an adapter, where local codes permit, a TEMPORARY
CONNECTION may be made to a properly grounded
two-prong wall receptacle by the use of a UL listed
adapter which is avail-
able at most local hard-
ware stores (Fig. 2). The
larger slot in the adapter
must be aligned with
the larger slot in the
wall receptacle to pro-
vide proper polarity in
the connection of the
I"EMPORARY METHOD
(ADAPTER PLUGS
NOT PERMITTED IN CANADA)
If' - ----3
ALIGN LARGE
~
PflONG&'SLOTS
~';~~~
\
@)l
------"-
', -J
v-
1 '~\
-L
%..\";
..%J4
~ ',"
\
#
.1 .-
' INW?E PROPER
=---
GROUND AND
FIRM CONNECTION
Fig. 2
BEFORE USE
#@Jow@rcord.
F*2
%=$AUTIONO Attaching adapter ground tertminal to
.
wall receptacle cover screw does not ground the
appliance unless cover screw is meta
—. .-...-——.
————
—-.———
—."".— .———
, and not in-
sulated, and wall receptacle is grounded thro~gh
house wiring. Customer should have the circuit
checked by a qualified electrician to make sure the
receptacle is properly grounded.
When disconnecting the power cord from the adap-
ter, always hold the adapter with one hand. If this
is not done, the adapter ground terminal is very
likely to break with repeated use. Should this hap-
pen, DO NOT USE the appliance until a proper
ground has again been established.
2.
THE FREEZER SHOULD ALWAYS 'BE PLUGGED
INTO ITS OWN INDMDUAL
IELECTRICAL OUTLET'
(115 volt, 60 hertz, single phase AC).
This is recom-
mended for best performance and to prevent over-
loading hbuse wiring circuits, which could cause a
possible fire hazard from overheating wires.
USE OF EXTENSION
CORDS–Because of poten-
tial safety hazards under certain conditions, we
strongly recommend against the use of an exten-
sion cord. However, if you still elect to use an
extension cord, it is absolutely necessary that it be
a UL listed 3-wire grounding type appliance exten-
sion cord and that the current carrying rating of the
cord in amperes be 15 amperes minimum. Such ex-
tension cords are obtainable through your local service
organization.
3. Repair or replace immediately all ekctric
ser-
vice cords that have become frayed or otherwise
damaged.
Do not use a cord that shows cracks or
abrasion damage along its length or at either the
plug or connector end.
4. Never unplug your freezer
by pulling on the
power cord.
Always grip the plug firmly and pull
straight out from the receptacle.
5. After your freezer k in operation, do not touch
the cold surfaces, particularly when hands are damp
or wet.
Skin may adhere to these extremely cold
surfaces.
6.
D(3 not
operate
your freezer in lhe pwxxxwe of
explosive fumes.
Advertisement
