Setting Up An Invisible Boundary Zone; What You'll Need; Set Boundary Zone Radius On Your Wireless Fence Unit; Set Static Correction Level To Level 2 Or 3 - Motorola TRAVELFENCE50 User Manual

6. Setting Up an Invisible Boundary Zone

6.1

What You'll Need:

1. Pet Collar Unit
2. Test Light
3. Wireless Fence Unit (see "Turn Fencing Mode On or Off" on page 27).
4. Training Flags
6.2

Set Boundary Zone Radius on your Wireless Fence Unit

1. Make sure that both the Pet Collar Unit and Wireless Fence Unit are
powered on (see "Powering On/Off the Pet Collar Unit" on page 23 and
"Powering On/Off the Wireless Fence Unit" on page 27).
2. Hold the Pet Collar Unit on your hand (avoid touching the collar contacts)
and walk to your desired boundary zone.
3. Press and hold down PAIR KEY
Collar Unit at the same time until you hear a long confirmation beep.
This indicates that the zone radius is set.
If you hear 10 short beeps, it means that the zone radius has not been set
successfully. Please repeat the above steps to set the zone radius. Note that
the maximum coverage area is 1 acre, equivalent to zone radius 120 feet
line of sight.
6.3

Set Static Correction Level to Level 2 or 3

Press or
6.4

Confirm Boundary Zone

Boundary zone is an area 2 to 3 feet before the "real" boundary. When your dog
reaches the boundary zone, the Pet Collar Unit that is worn on your dog emits a
warning beep followed by static correction to get its attention until it backs away
and goes back into the boundary. The maximum distance between the
boundary zone and the wireless fence unit is 120 feet.
1. Press and hold POWER KEY
2. Place the Test Light over the Collar Contacts on the Pet Collar Unit.
28
to select Static Correction Level (2 to 3).
and POWER KEY
on the Pet Collar Unit to power it on.
Setting Up an Invisible Boundary Zone
on the Pet