Console Port (Hub 12M And Hub 24M); Reset Button; Clear Button (Hub 12M And Hub 24M); Back Of The Hubs - HP ProCurve 10 Installation Manual

Console Port (Hub 12M and Hub 24M)

This port is used to connect a console to the hub by using the serial cable
supplied with the hub. This connection is described under "connect a Console
to the Hub" in chapter 2, "Installing the 10/100 Hubs". The console can be a
PC or workstation running an ASCII (TTY) or VT-100 terminal emulator, or an
actual ASCII or VT-100 terminal.

Reset Button

This button is used to reset the hub while it is powered on. This action clears
any temporary error conditions that may have occurred, restarts the hub and
executes the hub self test. A typical instance of where you might use the Reset
button is in the event of a hub malfunction or error condition.

Clear Button (Hub 12M and Hub 24M)

This button is used for deleting any hub console and web browser interface
passwords that you have configured for the hub. When pressed for at least ten
seconds, the button deletes the passwords. Use this feature if you have
misplaced the password and need console access.
N o t e
This button is provided for your convenience, but its presence means that if
you are concerned with the security of the hub configuration and operation,
you should make sure the hub is installed in a secure location, such as a locked
wiring closet.

Back of the Hubs

Power Connector

The 10/100 hubs do not have a power switch; they are powered on when
connected to an active AC power source. The hubs automatically adjust to
various voltages (depending on the country) between 100-127 and 200-240
volts and either 50 or 60 Hz. There are no voltage range settings required.
AC Power
Connector
Introducing the HP ProCurve 10/100 Hubs
Cooling vents - make sure
these are not obstructed for
proper hub operation
Back of the Hubs
1-5