Secure The Drive - Lenovo ThinkServe LTO User Manual

3. If the drive is the last device on the SCSI chain, make sure that the
SCSI cable is terminated correctly.
Note:

Secure the drive

Note:
November 2012
Termination must be present at two and ONLY two
positions on the SCSI bus—at the beginning of the
SCSI bus and at the end of the SCSI bus.
Termination is normally enabled by default on the
HBA and most internal SCSI cables have a
terminator attached. This will usually be a small,
rectangular block of plastic attached to the cable
end and marked 'SCSI Terminator'. Therefore,
assuming the HBA is the first device on the bus,
you should check that the second terminator is
placed after the last device.
Use 3 mm screws and, if you cannot tighten the screws,
use washers to secure them.

Secure the drive

#
33