Initial Settings - Kenwood KDC-U7053BT Instruction Manual

Initial settings

You can configure initial settings of this unit.
1
Select the Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter the Function setting mode
Press and hold the Control knob.
3
Select the Initial settings item
Turn the Control knob to select "Initial Settings",
and then press the Control knob.
4
Select a desired Initial setting item
Turn the Control knob to select an Initial setting
item, and then press the Control knob.
Display Description
"Initial Settings"
"SRC Select" Select "2" to change the source selection
method. Press the [SRC] button, turn the
Control knob to select the source, and then
press the Control knob to determine it.
1 / 2
"Key Beep"
Setting the operation check sound (beep
sound) ON/OFF.
"ON" / "OFF"
"TDF Alarm" If you turn off the engine key of the vehicle
without removing the panel, a beep sounds
for 30 seconds.
"ON" / "OFF"
"Chinese" When this is set to ON, the following character
strings are displayed in Chinese:
Folder name/ File name/ Song title/ Artist
name/ Album name
(KDC-U7053BT only)
"ON" / "OFF"
"TAG Language" When this is set to "Arabic", "Persian", or "Thai",
the following character strings are displayed in
Arabic, Persian, or Thai:
Folder name/ File name/ Song title/ Artist
name/ Album name
(KDC-U7053BTL only)
English / Arabic / Persian / Thai
"Function Language" Changes the display language of items
displayed in the Function setting mode.
(KDC-U7053BTL only)
English / Persian
"Built-in AUX" Sets whether to display AUX during source
selection.
"ON" / "OFF"
"CD Read" Sets the method for reading CD.
When unable to play a special format CD, set
this setting to "2" to force playing. Note that
some music CDs may be unplayable even
when set to "2".
In addition, audio files cannot be played when
set to "2". Normally, keep this set to "1".
1: Automatically distinguishes between the
audio file disc and music CD when playing
a disc.
2: Forces playing as a music CD.
"Built-in AMP" Selecting "OFF" turns off the built-in amplifier.
Turning off the built-in amplifier improves the
quality of the sound from Preout.
"ON" / "OFF"
"Speaker Select" Sets the speaker type so that the System Q
value is optimal.
"OFF": OFF
"5/4inch": For 5 & 4 in. speaker
"6x9/6inch": For 6 & 6x9 in. speaker
"O.E.M.": For the OEM speaker
"F/W Update" Upgrades the firmware.
Selecting "YES" and then pressing the Control
knob starts upgrading the firmware.
For how to update the firmware, access our
web site.
http://www.kenwood.com/cs/ce/
5
Select an Initial setting item
Turn the Control knob to select desired setting,
and then press the Control knob.
The previous item is displayed.
6
Exit the Function setting mode
Press and hold the [
( : Factory setting)
] button.
|
English
21