Electronic Stability Program (Esp) - Warning Lamp; Warning Lamp; Malfunction And Indicator Lamp In The Center Console; Airbag Off Indicator Lamp - Mercedes-Benz C-class Operator's Manual

Electronic stability program (ESP) — warning lamp
The yellow ESP warning lamp in the
speedometer dial comes on with the
electronic key in starter switch position 2.
It should go out with engine running.
If the ESP malfunction indicator lamp remains
illuminated with the engine running, a malfunction has
been detected in the system. Pressing the accelerator
pedal will require greater effort. Only partial engine
output will be available.
See electronic stability program (ESP) on page 260 if the
warning lamp lights up or flashes when the vehicle is
moving.
Seat belt nonusage warning lamp
With the electronic key in starter switch
position 2, the seat belt nonusage warning
lamp comes on, and a warning sounds for a
short time if the drivers seat belt is not fastened.
After starting the engine, the seat belt nonusage
warning lamp blinks for a brief period to remind the
driver and passengers to fasten seat belts.
Malfunction and indicator lamps
Instruments
Operation
and controls
Instrument
Driving
cluster display
Malfunction and indicator lamp in the center
console

AIRBAG OFF indicator lamp

The ü indicator lamp will light up for approximately
6 seconds when you turn the electronic key in starter
switch to position 1 or 2.
It does not light up if there is a fault in the system.
The ü indicator lamp stays lit as long as a
TM
Baby Smart child seat is properly installed on the
front passenger seat. It indicates that the front
passenger airbag is switched off.
See page 62 for BabySmart
system.
TM
Baby Smart is a trademark of Siemens Automotive Corp.
273
Practical hints Car care
TM
airbag and its deactivation
Technical
data
Index