Horizontal Surface Mounting - HP ProCurve Switch 1600M Installation Manual

Installing the Switch 1600M and 2400M
Installation Procedures
4.
install additional
screw

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. Use a sturdy surface
in an uncluttered area. You may want to secure the networking cables and
switch power cord to the table legs or other part of the surface structure to
help prevent people from tripping over the cords.
N o t e
Make sure the air flow is not restricted around the sides and back of the switch.
2-10
Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws.