Advertisement
Figure 4: Local Bus connections
AL-1191/AL-1193
Tamper
The reader has a tamper feature. When the reader is
connected to the system databus, tamper data is transmitted to
the Alliance system with system data. You can configure a
tamper control for both online and offline operation using an
external open collector output (violet wire)
Specifications
Current consumption
Standby
25 mA
Active
80 mA maximum
Input voltage
9 to 14 VDC
Operating temperature
32 to 120°F (0 to 49°C)
Humidity
85% noncondensing
Regulatory information
UL listings
UL 294 Standard for Access Control System
Units
UL 365 Standard for Police Station Connected
Burglar Alarm Units and Systems
UL 609 Standard for Local Burglar Alarm Units
and Systems
UL1610 Standard for Central Station Burglar
Alarm Units
UL 1635 Standard for Digital Alarm
Communicator System Units
Smart Card Reader AL1191, AL-1193 Installation Instructions
DGP
J8 to J12
1
C
2
C
Violet
4K7
3
C
J22
Green
D-
White
D+
Black
0V
Red
+12V
BZ
Yellow
Request-to-exit
FCC compliance
This device complies w ith part 15 of the FCC
rules. Operation is subject to the follow ing
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user's authority to operate the
equipment.
This equipment has been tested and found to
comply w ith the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communication. How ever, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, w hich can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the follow ing
measures:
Reorient or relocate the receiving antenna.
Increase the separation betw een the equipment
and receiver.
Connect the equipment into an outlet or a circuit
different from the one w here the receiver is
connected.
Consult the dealer or an experienced ratio-TV
technician for help.
FCC ID: CGGATS1190-1192.
Contact information
www.utcfireandsecurity.com
For customer support, see
support
© 2012 UTC Fire & Security Americas Corporation, Inc.
Interlogix is part of UTC Climate Controls & Security, a unit of
United Technologies Corporation. All rights reserved.
or
www.interlogix.com
www.interlogix.com/customer-
3
Advertisement
