KitchenAid 8301169 Installation Instructions Manual page 8

Installing the grille
or griddle.
Grille installation: Go to Step 16.
Griddle installation: The griddle is factory
installed. To complete the installation, go
to Step 17.
16.
Installing the grille:
log burner
A.
Lift the log burner up out of the bay
and set aside.
locating feet
rear spill
guard
drip
tray
B.
Place drip tray on bottom of grille
bay and slide the tray forward so that it is
located side-to-side and against the
locating feet of the rear spill guard.
insert feet
into slots
C.
Insert the front spill guard feet into
the slots in the rear spill guard as shown.
The rear flange will rest on the burner box.
8
D.
burner's rear flange is seated in slot.
E.
grounded outlet.
F.
Check the surface burner and grille
flames. Before completing the grille
installation, go to "Check the operation of
the surface burners, grille and griddle" on
Page 9.
G.
bay. The tab in the left rear corner of the
bay must fit through the slot in the left
rear corner of the wave tray.
front spill
guard
H.
tray as shown. The wave plate must be
centered on the wave tray.
I.
Install the grille grate.
Reinstall the log burner. Make sure
Plug power supply cord into
slot for
locating tab
Install the wave tray into the grille
wave
tray
Place the wave plate on the wave
17.
Completing the griddle
installation:
griddle drip
tray
A.
Place drip tray in the well at the
front of the griddle. Slide tray forward until
it stops.
B.
Refer to the Use and Care Guide
that came with your Cooktop for
instructions on cleaning and seasoning
the griddle before using.
C.
locating
Plug power supply cord into
tab
grounded outlet.
D.
Check the surface burner and
griddle flames. Go to "Check the
operation of the surface burners, grille
and griddle" on Page 9.
wave
plate
griddle