Table of Contents
Advertisement
WEEKLY MAINTENANCE
1. Check fluid level in batteries.
2. Check batteries for loose or corroded cables.
3. Keep battery tops clean from corrosion.
MONTHLY MAINTENANCE
1. Check machine for leaks and loose fasteners.
2. Lubricate all grease points and pivot points
with silicon spray and approved grease.
3. Place machine over a floor drain. Flush
solution system by pouring 3 gallons of hot
water and approved alkaline detergent into
the solution tank and running machine (with
solution control on) for 45 seconds. Turn
machine off and let it sit overnight. Then
next day, drain the remaining solution and
rinse the solution tank out with clean water.
VACUUM MOTOR MAINTENANCE
1. Contact your local Distributor for any motor
maintenance.
2. Vacuum motor should have the brushes
checked every 250 hours. Brushes should be
replaced when they are worn to a length of
10mm or less.
BATTERY MAINTENANCE
For the best machine
performance, keep
batteries charged at all times. Do not let
them sit in a discharged condition.
Batteries are dangerous!
Batteries emit hydrogen
gas and an explosion or fire can result.
Keep sparks and fire away from batteries at
all times.
Whenever servicing
batteries, be sure to wear
protective gloves. Avoid contact with
battery acid at all times!
1. Always follow the battery charging directions
as outlined in the BATTERY CHARGING
section of this manual.
2. Keep battery tops and terminals free from
corrosion. A strong solution of baking soda
and water is the best way to keep the
batteries corrosion free.
DO NOT ALLOW THE BAKING SODA /
WATER SOLUTION TO ENTER THE BATTERY
CELLS.
3. Use a wire brush with the baking soda
solution to properly clean the battery posts
and connections.
4. Check battery connections for wear and loose
terminals. Replace if necessary.
MACHINE STORAGE
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright
position.
4. Always store the machine with the pad driver
/ brush raised off the floor.
5. Always store the machine with the squeegee
assembly raised off the floor.
6. If storing in an area which may reach freezing
temperatures, be sure to drain all fluids from
the machine prior to storage. Any damage
caused by freezing temperatures will not be
covered by the warranty.
7. Drain the recovery tank and remove the clear
on the top of the recovery tank so that it can
"breathe" during storage.
8. Drain the solution tank of all fluid.
9
Advertisement
Table of Contents
