ZyXEL Communications ZyWALL 70 Quick Start Manual page 5

1.3 The Front Panel LEDs
The PWR LED turns on when you connect the power. The SYS LED blinks while performing system testing
and then stays on if the testing is successful. The ACT, CARD, LAN, WAN and DMZ LEDs turn on if the
corresponding connections are properly made. Refer to the following table for more detailed LED
descriptions.
LED COLOR
PWR
Green
Red
SYS Green
ACT Green
CARD Green
LAN
10/100
Green
Orange
WAN-1/2
10/100
Green
ZyWALL 70 Internet Security Appliance
STATUS
Off The ZyWALL is turned off.
On The ZyWALL is turned on.
On The power to the ZyWALL is too low.
Off The ZyWALL is not ready or has failed.
On The ZyWALL is ready and running.
Flashing The ZyWALL is rebooting.
Off The backup port is not connected.
Flashing The backup port is sending or receiving packets.
Off The wireless LAN is not ready, or has failed.
On The wireless LAN is ready.
Flashing The wireless LAN is sending or receiving packets.
Off The LAN is not connected.
On The ZyWALL has a successful 10Mbps Ethernet connection.
Flashing The 10M LAN is sending or receiving packets.
On The ZyWALL has a successful 100Mbps Ethernet connection.
Flashing The 100M LAN is sending or receiving packets.
Off The WAN connection is not ready, or has failed.
On The ZyWALL has a successful 10Mbps WAN connection.
Flashing The 10M WAN is sending or receiving packets.
DESCRIPTION
4