Advertisement
General
Read these instructions carefully. Failure to follow them could damage the product or cause a
hazardous situation.
Select thermostat location
Select a location for the
thermostat approximately 1.5 m
above the floor on an internal wall,
and in the location that requires
heating.
DO NOT install the thermostat
where it can be affected by:
-
draughts (hallways, regular
accessed doorways etc.)
-
hotspots (direct sunlight,
above fireplaces/heaters,
warm air ducts etc.)
-
deadspots where air does
not circulate freely (alcoves,
corners, behind doors etc.)
Installing the thermostat
Before installing the thermostat
make sure the electrician has
preinstalled the RJ45 cable.
1.
Take the thermostat out of the
box, and remove the wall plate
from the face plate.
2. Connect the adaptor provided
to the RJ45 cable.
3. Push everything back into the
wall and secure the wall plate
to the wall.
4. Secure the face plate to the
wall plate.
4 | iHeat thermostat installation guide: 12064-A 01-13
RJ45 cable
RJ45 cable preinstalled by electrician
1. Remove wall plate from face plate
Advertisement
