Table of Contents
Advertisement
Using an Additional Battery for Increased Run Time
Your model only requires one battery pack, but the chassis can accept
two batteries. Your model can be run with two battery packs to
extend run time. The batteries must be connected in parallel, which
will combine the capacity of the two batteries
(for example, two 7.2-volt 1000mAh packs connected in parallel will
deliver a total capacity of 2000mAh, but total voltage will remain 7.2
volts). This is easily done with a parallel Y-harness (Part #3064, sold
separately). Be sure to only use the Y-harness with identical battery
packs; do not mix batteries of different chemistries or capacities.
When operating your model with two batteries, be careful
to monitor the temperature of the speed control and motor
to prevent overheating. Stop running your model and allow
it to cool if the speed control's thermal overload protection
activates or if the motor temperature exceeds 200°F.
For best off-road handling with two battery packs, consider
installing stiffer springs on your model. Traxxas offers
accessory springs for this purpose; see the parts list included
with your model for part numbers.
RADIO SYSTEM RULES
• Always turn your transmitter on first and off last. This procedure will
help to prevent your model from receiving stray signals from another
transmitter, or other source, and running out of control. Your model
has electronic failsafes to prevent this type of malfunction, but the
first, best defense against a runaway model is to always turn the
transmitter on first and off last.
• Always turn on the transmitter before plugging in the battery.
1
2
Always turn your
Plug in the battery.
transmitter on first.
• Always use new or freshly charged batteries for the radio system.
Weak batteries will limit the radio signal between the receiver and
the transmitter.
Loss of the radio signal can cause you to lose control
of your model.
TRAXXAS TQ 2.4GHz RADIO & VELINEON POWER SYSTEM
RADIO SYSTEM CONTROLS
• In order for the transmitter and receiver to bind to one another,
the receiver in the model must be turned on within 20 seconds
of turning on the transmitter. The transmitter LED will flash fast
red, indicating a failure to link. If you miss it, simply turn off the
transmitter and start over.
RADIO SYSTEM BASIC ADJUSTMENTS
Steering Trim
The steering trim knob located on the face of the
transmitter adjusts the neutral (center) point of the steering
channel. If your model pulls to the right or left when the
steering wheel is centered, turn the knob until the model drives
3
straight when the steering wheel is centered.
Channel Reversing
The TQ 2.4GHz transmitter has been programmed with the correct servo
direction settings for your model and should not require adjustment.
These instructions are for reference and troubleshooting only.
Turn on the model.
Reversing a channel reverses the direction of the corresponding servo.
For example, if you turn the steering wheel to the right and the model
turns left, Channel 1 would need to be reversed to correct the servo
direction. Use the following procedures to reverse the steering and
throttle channels, if necessary. Servo reversing should only be required
if you accidentally reset the direction of a channel. Do not reverse the
steering or throttle channels unless necessary.
Neutral
Brake/Reverse
Forward
Make certain the model's
receiver antenna is properly
installed before operating
your model. See "Installing
the Receiver Antenna."
Failure to properly install the
receiver antenna will result in
greatly reduced radio range
and potential loss of control.
Remember, always turn
the transmitter on first and
off last to avoid damage to
your model.
When rechargeable batteries
begin to lose their charge,
they will fade much faster
than alkaline dry cells. Stop
immediately at the first sign
of weak batteries. Never turn
the transmitter off when the
battery pack is plugged in.
The model could run out of
control.
6
1/16 E-REVO VXL • 13
Advertisement
Table of Contents
