Indesit PI 631 Operating Instructions Manual
Hide thumbs
Also See for PI 631:
- Operating instructions manual (57 pages) ,
- Operating instructions manual (56 pages)
Table of Contents
Advertisement
Quick Links
Operating Instructions
GB
IT
GB
IE
Italiano, 1
English,12
ES
Español, 35
Português, 46
PI 631
PI 631 A
PI 631 IB
PI 640 IB
PI 640
PI 640 A
PI 640 AS
PI 640 AST
PI 640 A R
FR
Français, 23
PT
Contents
Installation, 13-17
Start-up and use, 19
Disposal
Troubleshooting, 22
HOB
Advertisement
Table of Contents
Related Manuals for Indesit PI 631
Summary of Contents for Indesit PI 631
-
Page 1: Table Of Contents
Practical advice on using the electric plates Precautions and tips, 20 General safety Disposal PI 631 Maintenance and care, 21 PI 631 A Switching the appliance off PI 631 IB Cleaning the appliance Gas tap maintenance PI 640 IB PI 640... -
Page 2: Installation
Installation Before operating your new appliance please read The system can also provide Adjacent Room to be this instruction booklet carefully. It contains important the air needed for combustion Room Vented information for safe use, installation and care of the indirectly, i.e. -
Page 3: Electrical Connection
Fastening hooks are provided, allowing you to fasten the hob to tops that are between 20 and 40 mm thick. To ensure the hob is securely fastened to the top, we recommend you use all the hooks provided. 555 mm Where a hob is installed above an oven without a forced ventilation cooling system, adequate ventilation must be provided inside the cabinet by means of air... -
Page 4: Gas Connection
Before connecting to the power supply, make sure There is an adjustable L-shaped pipe fitting on the that: appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be • The appliance is earthed and the plug is compliant replaced after rotating the pipe fitting (seal provided with the law. -
Page 5: Data Plate
• Setting the burners to minimum: If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as 1. Turn the tap to the low flame position. possible. 2. Remove the knob and adjust the adjustment screw, Once this procedure is finished, replace the old which is positioned in or next to the tap pin, until rating sticker with one indicating the new type of gas... -
Page 6: Burner And Nozzle Specifications
PI 640 PI 631 PI 640 AST PI 640 A PI 631 IB PI 640 IB PI 640 AS PI 640 A R The PI 640 AST hob can only be installed above built-in ovens with a cooling ventilation system. -
Page 7: Description Of The Appliance
Description of the appliance Overall view GAS BURNERS ELECTRIC HOTPLATE* ELECTRIC HOTPLATE Support Grid for indicator light* COOKWARE Control Knobs for GAS BURNERS and ELECTRIC HOTPLATES* GAS BURNERS button* SAFETY DEVICES* Ignition for GAS BURNERS* • Control Knobs for GAS BURNERS and ELECTRIC •... -
Page 8: Start-Up And Use
Start-up and use Practical advice on using the burners The position of the corresponding gas burner or electric hotplate* is shown on every knob. To ensure the burners operate efficiently: Gas burners Each burner can be adjusted to one of the following •... -
Page 9: Precautions And Tips
Precautions and tips This appliance has been designed and • In case of malfunction, under no circumstances manufactured in compliance with international safety should you attempt to repair the appliance yourself. standards. The following warnings are provided for Repairs carried out by inexperienced persons may safety reasons and must be read carefully. -
Page 10: Maintenance And Care
Maintenance and care Switching the appliance off Gas tap maintenance Disconnect your appliance from the electricity supply Over time, the taps may become jammed or difficult to before carrying out any work on it. turn. If this happens, the tap must be replaced. This procedure must be performed by a qualified Cleaning the appliance technician authorised by the manufacturer. -
Page 11: Troubleshooting
Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open.