Browser Operation; Connecting The Center Module Via A Pc; Setup Instructions - Panasonic WX-CC411 Operating Instructions Manual

Browser Operation

w Connecting the Center Module
w
via a PC
1
Launch the PC's Web browser.
2
Input the Center Module IP address into the
address bar of the Web browser.
Example) http://Center Module IP address
This unit has the following default settings as
the time of shipment:
IP address:
Port number: 80
Protocol:
Important
w p If the HTTP port number has changed from "80", input
[http://Center Module IP address: port number] into
the [Address bar].
Example) If the port number is set to 8080:
http://192.168.0.50:8080
3
When a connection has been established
between the Center Module and the PC, an
authentication pop-up screen will appear. Input
the username and password.
The following are the default setting username and
password:
Username: admin
Password: 12345
w p If authentication is successful, the operation screen
will appear.
Note
w p The IP address of the Center Module can be checked
on the Center Module screen. For details, refer to the
Operating Instructions <Installation Guide>.
Important
w p Be sure to change the username and password to
ensure that the system is secure. For details, see
"Configuring server settings" (p. 13).
192.168.0.50
http
w Setup Instructions
w
This section describes basic operation procedures to set
this unit with browser operations.
1
Input the necessary information into the
settings.
2
Click the [Set] button.
Important
w p The settings will not be reflected unless the [Set]
button is clicked.
w p Do not click the button repeatedly. Doing so may
result in the settings being set incorrectly.
9
2
1