Customising Settings (System Settings); System Settings - Sharp AR-6020 Operation Manual

CUSTOMISING SETTINGS
The system settings allow you to customise the machine to match your needs.

SYSTEM SETTINGS

Program
Program name
number
1 Auto clear time
2 Preheat mode
Auto power
3
shut-off timer
Stream feeding
4
*1
mode
Border line for 2
6
IN 1 / 4 IN 1
7 Rotation copy
Auto paper
8
select mode
Setting codes
(factory default setting
appears in bold)
1: OFF
2: 10 sec.
3: 20 sec.
4: 60 sec.
5: 90 sec.
6: 120 sec.
1: 1 min.
2: 5 min.
3: 15 min.
4: 30 min.
5: 60 min.
1: 5 min.
2: 15 min.
3: 30 min.
4: 60 min.
0: OFF
1: ON
1: OFF
2: Solid line
3: Broken line
0: OFF
1: ON
0: OFF
1: ON
(System Settings)
Explanation
• "Auto clear time" automatically returns the copy
settings to the initial settings
period of time elapses after a copy is made. This
program is used to select the period of time. "Auto
clear time" can also be disabled.
• This function automatically switches the machine to a
low power consumption state if the set duration of
time elapses without the machine being used when
the power is on. The POWER SAVE indicator (
lights up, however, the keys on the operation panel
can be used. Normal operation automatically
resumes when a key on the operation panel is
pressed, a print job is received or an original is
placed.
• This function automatically switches the machine to a
state that consumes even less power than preheat
mode if the set duration of time elapses without the
machine being used when the power is on. All lights
except the POWER SAVE indicator (
ONLINE indicator go off. To resume normal
operation, press the [START] key (
Normal operation also resumes automatically when a
print job is received. While in auto power shut-off
mode, no keys (except the [START] key (
used.
• When copying using the RSPF, during the period of
time that the RSPF indicator blinks after an original
has been scanned (about 5 seconds), a subsequent
original can be placed and automatically fed into the
machine.
• When copying multiple originals onto a single sheet
of paper (2 IN 1 / 4 IN 1 copy), this function can be
used to print a solid or broken borderline around each
original image.
• When the auto paper select function is enabled and
there is no paper that is the same size as the original
and loaded in the same orientation, this function will
automatically select paper of the same size that is
loaded in the opposite orientation, and rotate the
image 90 degrees so that it is copied on the paper in
the correct orientation.
• When the auto ratio select function is operating and
the original and paper are loaded in opposite
orientations, this function rotates the image so that it
is copied on the paper in the correct orientation.
• This function automatically selects paper that is the
same size as the original placed in the RSPF, or the
same size as that selected with the [ORIGINAL] key
( ). The function can be disabled.
(p.37) when a certain
)
) and
).
)) can be
91
6