Page 9
Warning ! People with electronic medical implants (pacemakers, etc.) and pregnant women should stay away from this appliance during operation. ! To extend the appliance’s using life, don’t pull out the power cord immediately, you should wait until the exhaust fan to stop working.
12cm from all sides of the wall. Thank you for choosing a - Never use the induction NESCO appliance.The experi- cooker in high temperature ence, design, feature and tech- environments such as near a nology of this appliance, as well gas stove or kerosene stove.
Page 11
manufacturer, its service agent covers so as to avoid any or similarly qualified persons dangers of explosion due to in order to avoid hazard. heating expansion Cautions - After being used for a long time, the corresponding heating - Before positioning a pot, zone of the induction hotplate please clear water mark/ is still hot.
Page 12
is in working or protective product, the product will be mode, first press the “ON/ shut. OFF” button to have the - Press the “ON/OFF” button, induction cooker to enter the product is working with standby mode, then take off the power function, and the plug after the fan stops.
fourth time, the “min” and “C” the user has not put a proper are red, the displayer show pot in time, the induction “000”, you could adjust the cooker can return to standby time by turning the knob from automatically. 1 min to 240 minutes.
Page 14
If the induction cooker Code Failure operates for two hours and no Main PCB at Fault key is pressed in working Top plate over heat mode, it will go to standby Applicable Pots: mode automatically (except that timing period exceeds two hours).
by the utensil’s material. cooker surface with a rigid - After the first use, some brush. white spots would appear at the 2. Air vent and air entry button of the pot. This is normal. - The induction cooker body Please pour some vinegar into shall be cleaned lightly with the pot, heat it at about 60-80 ํ...