Advertisement
Disconnect the plug from the electrical socket
minutes. Ensure heater is not covered and
obstructing any of the vents. Plug the heater
electrical socket and switch the heater back ON.
KEY / PARTS LOCATION
1. ON/OFF switch control
2. Adjustable thermostat
3. Pilot light indicator
4. Front air grid
5. Carry handle
6. Cord & plug
7. Front legs
HOW TO OPERATE
1. Remove the unit from the box and take off any protective wrappings.
2. Place the heater on a smooth level surface and at least 30cm away from any obstacles.
3. Plug your fan heater into the power supply. Make sure your power supply corresponds to the
power indicated on the rating label.
NOTE: Fan speed cannot be altered and will always remain constant.
4. Heat temperature settings can be regulated using the switches located on the top of the heater.
This switch is used for both the fan and heat elements. Note the fan speed cannot be altered and
will always remain constant. To turn the appliance on :
Fan – for a low power air circulator - turn the dial on the right clockwise, once for the
fan function.
Low - Turn it twice for the Medium heat setting (1000W). This setting is best suited for
smaller, well-insulated areas that require less warming.
High - Turn the switch once more for Hi setting, or full power (2000W), which delivers
rapid warm air to increase the temperature to a given area.
Thermostat :
An adjustable thermostat control has been built into the heater, allowing you to choose how warm you
wish an area to be.
Turn the thermostat clockwise to operate.
NOTE: When the heater is in the Hi or Low position the thermostat dial must be turned to the left in
order for the fan to work.
At the "High" - setting (the thermostat control is turned all the way to the right) the room will heat up
quickly.
At the "Low" setting (the thermostat is positioned to the left) the room will maintain room temperature
and slowly disperse heat.
OVERHEATING SAFETY DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of overheating.
Should the heater stop working, turn the heater off and inspect for blockage of inlet or outlet. Wait at
least 5 minutes for the protection system to re-set before attempting to re-start the heater.
for a few
nothing is
back into the
3
Advertisement
