GE 14 Use And Care Manual With Installation Instructions page 14

REVERSE CABINET HARDWARE.
1. Transfer the bottom hinge to the left.
a. Remove the base grille if your refrigerator has
one. Grasp it at the bottom and pull it straight out.
b. Using a Torxdriver, remove the hinge bracket
(and shim glued to it), and plastic washer from
the bottom right side of the cabinet.
c. Reinstall the hinge bracket (and shim glued
to it) and plastic washer on the bottom left side
of the cabinet.
2. Transfer the top hinge to the left.
a. Remove the screws from the top left front
corner of the cabinet and reinstall them on the
right side.
LEFT SIDE
Reinstall the top hinge (and shim glued to it)
b.
on the left front corner of the cabinet, but do not
tighten the screws at this time.
REVERSE THE DOOR HANDLES.
(on some models)
1. Transfer the fi-esh food door handle
to the right.
IDE
/
Remove the handle plug using a tape-
a.
tipped putty knife under the edge, and remove
the screw underneath.
b. Remove two screws holding the handle to the
top of the door.
c. Remove the hanclle.
Remove the screws from the right edge of
a.
the door top and insert them into the handle
screw holes on the opposite side.
With ~ape-tipped PLUG
b.
putty kmfe or thin-
blade screwdriver,
pry out the plug
button from the
hole on the opposite
side that
was
vacated by removal
of the top hinge.
c. Pull the plug
button from the
front of the door and
transfer it to the
opposite side.
L
BUTTON
A
PLUG BUTTON