Classic, Architect; And Complete Series Custom Side Panels - KitchenAid 2316565B Installation Manual

Dispenser Frame (Classic Series dispenser models)
The dispenser frame attaches to the panel with 4 screws.
To remove the dispenser frame:
1. Remove the four screws attaching the frame.
2. Pull the dispenser frame from the decorative panel.
3. To replace the frame, hold the frame to the panel and replace
the screws.
A
A. Dispenser frame
The dispenser frame overlaps the dispenser cutout by
(0.78 cm) on each side and
The custom panel can be a maximum of
behind the frame where it overlaps the cutout.
A
A. " (1.27 cm) Overlap
" (1.27 cm) on the top and bottom.
" (6.35 mm) thick
A

Classic, Architect

Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
may not reflect the needed panel installation dimensions.
The side panel should be a minimum of ½" (1.27 cm) thick to
avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may want to
install a support board on rear wall.
Refrigerator
24 "
(61.3 cm)
23
(60.3 cm)
Side Trim
"
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add
panel to fit into the trim.
2. If the panel is more than
edge to allow the side panel to fit into the trim.
® and Complete Series
Custom Side Panels
"
23 "
(59.7 cm)
"
(6.35 mm)
(4.5 mm)
"
(4.7 mm)
"
(5.5 mm)
"
" (10 mm)
(15.7 mm)
" (5.6 mm) to this measurement to allow the side
" (6.35 mm) thick, route the front
A
"
17