Using The Verification Tone; Troubleshooting - Siemens Gigaset Repeater Setup & User Manual

Using the verification tone

The verification tone enables you to establish whether or not the handset is working in the
extended area of the Gigaset Repeater. This tone is audible on the activated handset as
long as the unit is connected to the Gigaset Repeater.
Carry out the procedure described below on your Gigaset Repeater in order to switch the
verification tone on and off:
$ Switch off the unit (disconnect the power plug)
●
Switch on for 1 to 5 seconds and switch it off again.
$
●
$ Switch on again. If the left LED on the unit is flashing slowly, switch it off again.
●
Switch it on again. The verification tone is then activated or deactivated.
$
●
Miscellaneous

Troubleshooting

Problem
Left LED flashes conti-
nuously when the registra-
tion procedure has been
concluded
Left LED flashes conti-
nuously at a selected locati-
on
Left LED does not light up at
all
No reception of the handset
in the area of the repeater
Cause
No radio connection to
the base station
No radio connection to
the base station
No power
Repeater not registered
No radio connection to
the base station
Handset cannot find the
repeater
Miscellaneous
Action
Repeat registration
Select a new location
Check the power point
Repeat registration
Select a new location
Switch handset on and off
13