Installation; Led Display Of Functions - Siemens Gigaset Repeater Setup & User Manual

Installation

The Gigaset Repeater is now ready to be registered again as described above. This is sig-
nalled by the LED which flashes continually once the power plug is reconnected.
Installation
Once you have registered your Gigaset Repeater you can install it wherever you would like
to extend the reception range of your handsets. However, you must ensure that there is a
power point at the place of installation and that the left LED remains on constantly after
the device has been switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or recep-
tion is being hindered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a
good connection with the base station at the Gigaset Repeater installation site.
To operate a handset for the first time in the extended Gigaset Repeater area, switch off
the handset within the new reception range of the Gigaset Repeater, but outside the
reception range of the base station and then switch it back on again:
If you are using more than one Gigaset Repeater in the area of your base station,
you must keep the Gigaset Repeaters at least 10m apart.

LED display of functions

There are two green LEDs on the centre front of the housing. The left LED displays regist-
ration and operation function, the right LED displays the handset-traffic via this repeater:
Left LED states:
Dark
Flashing
Continuous lighting
Intermittent flashing
Right LED states:
Dark
Flashing once
Flashing twice
12
Base station
power supply off
no link to basestation
normal link to basestation
ready to register
no traffic
one handset link via repeater
two handset link via repeater
Extended reception area