Tool Specifications; Initial Operation; Product Features - Bosch GGW 10 E PROFESSIONAL Operating Instructions Manual

3 609 929 A82.book Seite 3 Mittwoch, 22. Februar 2006 8:40 08

Tool Specifications

Tapper
Article number
Rated power input [W]
Output power [W]
Rated speed
- Right rotation [rpm]
- Left rotation [rpm]
No-load speed
- Right rotation [rpm]
- Left rotation [rpm]
Cutting capacity
for threads
Tightening of
stud bolts
Weight without
cable, approx. [kg]
Safety class
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of 230/
240 V. However, these values can vary for lower voltages
and models made for specific countries.

Product Features

The numbering of the product features refers to
the illustration of the power tool on the graphics
page.
1 Two-jaw chuck*
2 Hexagon nut
3 Lock-on button for On/Off switch
4 Speed dial for speed preselection
5 On/Off switch
6 Wing bolt for depth stop adjustment *
7 Wing bolt for auxiliary handle adjustment *
8 Auxiliary handle*
9 Depth stop*
10 Chuck key for two jaw chuck*
11 Stud-bolt chuck*
12 Rapid-change chuck*
13 Roller clutch*
14 Adapter for roller clutch*
15 Wedge*
* Not all of the illustrated or described accessories are
included as standard delivery.
6 • 3 609 929 A82 • TMS • 09.02.06
Inserting the Tool
Two-jaw Chuck (see figure
GGW 10 E
PROFESSIONAL
Insert the tap into the two jaw chuck 1 and tighten
0 601 462 8..
it with the two jaw chuck key 10 .
500
270

Initial Operation

0 – 350 Always use the correct voltage: The voltage of
the power source must agree with the values on
0 – 600
the nameplate of the tool.
0 – 580
Switching On and Off
0 – 1 000
To start the tool, press the On/Off switch 5 and
keep it pressed.
M 4 – M 10
M 4 – M 12
2.7
/ II
trolled starts. Do not strain the machine so
heavily that it comes to a complete stop.
To lock on, push and hold the On/Off switch 5
and press the lock-on button 3.
To switch off the machine, release the On/Off
switch 5 or, when locked with the lock-on but-
ton 3, briefly press the On/Off switch 5 and then
release.
Speed Preselection
With the speed dial 4, the required speed can be
selected even if the machine is running.
The required speed depends on the material and
can be determined by practical testing.
After working with the machine for long periods at
low speed, allow it to cool by letting it run for ap-
prox. 3 minutes at maximum speed with no load.
Automatic Reversing of the Rotational
Direction
The tapper is equipped with a changeover gear-
box for clockwise rotation and accelerated coun-
terclockwise reverse rotation.
Under no load, the machine runs in counterclock-
wise direction and will switch automatically to a
clockwise direction when placed against the
workpiece. Gently pulling back the machine will
cause it to run counterclockwise.
English - 3
)
A
The machine runs with variable
speed between 0 and maximum
depending on the pressure applied
to the On/Off switch 5 . Light pres-
sure results in a low rotational
speed, thus allowing smooth, con-