Trailer Hitch Bracket; Brake Pedal; Accelerator Pedal - Polaris 2013 Ranger EV Owner's Manual For Maintenance And Safety

Trailer Hitch Bracket

This vehicle is equipped with a receiver hitch bracket for a trailer hitch. Trailer towing equip-
ment is not supplied with this vehicle.
To avoid injury and property damage, always heed the warnings and towing capacities out-
lined on pages 35-36.

Brake Pedal

Push the brake pedal toward the floor to slow or stop the vehicle. Apply the brakes before
turning the key on.

Accelerator Pedal

The accelerator pedal will function only when the key is
ON and the direction selector switch is set to either for-
ward or reverse. To begin moving or to increase vehicle
speed, gradually push the accelerator pedal toward the
floor. Holding the accelerator pedal down continuously
will accelerate the vehicle to the maximum speed.
To slow the vehicle, release the accelerator pedal. Elec-
tric motor braking provides braking when the pedal is
released. For additional speed control or to stop the vehi-
cle, apply the service brakes.
Roll-Over Protection System (ROPS)
The Rollover Protective Structure (ROPS) on this
vehicle meets OSHA 1928.53 rollover
performance requirements. Always have your
authorized POLARIS dealer thoroughly inspect
the ROPS if it ever becomes damaged in any way.
No device can assure occupant protection in the
event of a rollover. Always follow all safe operat-
ing practices outlined in this manual to avoid vehi-
cle rollover.
WARNING! Vehicle rollover could cause severe injury
or death. Always avoid operating in a manner that could
result in vehicle rollover.
Seat Removal
Pull up on the front of the seat to disengage the front latches. Slide the seat forward and lift it
away from the seat base.
To reinstall the seat, align the rear seat tabs with the slots on the rear of the seat base. Slide
the seat fully rearward, then push down firmly along the front edge of the seat to secure the
latches.
FEATURES AND CONTROLS
Brake
Pedal
ROPS Cab
Frame
Accelerator
Pedal
27