Maintenance; Replacing Parts - Whirlpool AGB 483/WP Instructions For Installation, Use And Maintenance Manual

Fig. 3A
6
4
5
1

5.2 Maintenance

Attention! Before doing any repair or maintenance
work, unplug the appliance.
The following maintenance program should be carried out at least
once a year:
• Check that all the safety and adjustment devices are working
properly;
• Check that the burners are working properly with regard to:
- ignition
- combustion safety;
Check functioning of the appliance as described in paragraph
"Operation Control";
If it should be necessary to clean the open flame burners, proceed as
follows:
• Clean the grills, covers and bodies of the burners;
• Clean the parts with water and detergent and an appropriate
tool. Rinse and dry.
When reassembling the parts, make sure you place them back in the
right position.
If it is necessary to clean the oven burner (18) (Fig. 2A/2B/2C), pro-
ceed as follows:
• Loosen the screw (2), run the air adjustment into the venturi
tube and remove it, unscrew the injector (3) and the nut or screw
(9).
• Unscrew the fastening screw (19) (Fig. 2A) of the burner and
remove it;
• Carefully clean all the holes of the burner with the aid of a tip of
a suitable size;
• Check that the smoke discharge is clear.
• Reinstall everything in reverse order.
064_03 - GAS KITCHENS
5 - SET-UP FOR OPERATION
3 2
7

5.3 Replacing parts

To replace the following parts first remove all the control knobs and
control panel (after loosening the fixing screws), then extract the
ignition wire.
5.3.1 Open flame gas valve (Fig. 1 – Pos. 4)
Loosen the fitting of the pipes (6) and (9) of the gas and of the
thermocouple (8), loosen the fitting (7) for the fastening of the
valve on the ramp and replace the piece.
5.3.2 Open flame thermocouple (Fig. 1 – Pos. 14)
Loosen the nut (8) for fastening the thermocouple on the valve e la
vite (18) del supporto (17) and replace the piece (14).
5.3.3 Gas ring ignition plug (Fig. 1)
Remove the pan support, the flame distributor, the crown and the
the burner crown support, svitare la vite (18), sollevare il supporto
(17), pull out the spring using a pointed tool, remove the ignition
plug from the bottom, disconnect the ignition lead and insert a new
plug.
5.3.4 Plug of gas oven (Fig. 2A/2B - Pos. 6)
Unscrew the fastening screws and remove the lower panel, extract
the ignition wire and unscrew the screws (15). Insert a new plug.
5.3.5 Gas oven gas valve (Fig. 3A/3B)
Loosen the fittings (1,2,3,4 in fig. 3A and 1,2,3 in fig. 3B) which are
for the connection for the gas pipe and the thermocouple, remove
the coil of the thermostat from its place in the cooking chamber
and put in a new piece in the reverse sequence.
5.3.6 Gas oven thermocouple (Fig. 2A/2B/2C and 3)
Unscrew the screws (15) and the nut (16) for fastening the thermo-
couple to the extension of thermocouple and insert the new piece.
16 · 26
Fig. 3B
6
5
0
All parts must be replaced by authorized technicians
only!
3
2
1
07/2007