Proceed As Follows; Light (Led); Tips For Saving Energy - Siemens KG..N.. Instructions For Use Manual

Proceed as follows:

1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Take out the frozen food and store in
a cool location. Place the ice pack (if
enclosed) on the food.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. After cleaning reconnect and switch
the appliance back on.
7. Put the frozen food back in the freezer
compartment.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Removing the container
Fig. 6
Pull out the container all the way, lift at
the front and remove.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Do not block the ventilation openings
■
in the appliance.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
Ensure that the freezer compartment
■
door is always closed properly.
Occasionally clean the rear
■
of the appliance to prevent an
increased power consumption.
If available: Fit wall spacers to obtain
■
the indicated energy rating of the
appliance (see Installation
instructions). A reduced wall gap will
not restrict the function of the
appliance. The energy rating may then
change slightly. The gap of 75 mm
must not be exceeded.
en
15