Congratulations on the purchase of your BladeRunner Series R/C Helicopter. The BladeRunner Extreme Indoor Rescue
Helicopter is designed for fun and easy flying. Even though the BladeRunner Extreme Indoor Rescue Helicopter is
easy to fly, the helpful tips in this pilot's manual will enhance your skill, so take time to read the following pages and learn about
PILOT INFORMATION MANUAL
PILOT INFORMATION MANUAL
PILOT INFORMATION MANUAL
1. Rescue Helicopter.
2. Portable Charger.
3. Radio Transmitter.
4. Radio Transmitter Antenna.
5. Rescue Figure.
6. Rescue Line.
Also required; (not included)
One 9V alkaline battery (transmitter).
Four C size alkaline batteries (charger).
Basic Assembly:
1)Insert the antenna into the
transmitter and screw firmly into
place finger tight (as shown).
2) If desired, install the rescue
line to the landing gear
(as shown).
ON BOTH SIDES
your helicopter. Look for these
PACKAGE CONTENTS:
PRE FLIGHT- SYSTEM PREPARATION
The Helicopter Charger requires
four C size alkaline batteries to
charge the Helicopter.
Installation:
1) Open the charger battery cover
by removing the screws.
2) Be sure to install the batteries
in the correct orientation
(as shown).
3) Replace the battery cover and
secure by tightening the screws.
FOR BEST PERFORMANCE
ONLY USE NEW ALKALINE
BATTERIES, DO NOT MIX
HOOK LINE
OLD AND NEW BATTERIES.
TM
symbols for extra help.
The transmitter requires
one 9V alkaline battery.
Installation:
1) Open the battery cover.
2) Install the battery with correct
polarity.
3) Replace the battery cover.
4) Move the throttle to the full ON
position and back to the transmitter
position to initialize the controller.
The power LED lights.
TM
8