JBL Simply Cinema ESC 360 Simple Setup Manual page 11

(Center), RF (Right Front), LS
(Left Surround), RS (Right Sur-
round) and SUB (subwoofer)
will illuminate to indicate the
active speaker. The level for
the selected channel can then
be changed using the Adjust-
ment +/– buttons (11). Levels
set in one mode will stay valid
for all other modes and are not
independent. Please note that
the status-bar indicator (27)
will not display unless Adjust-
ment +/– buttons are pressed.
And, while the status-bar indi-
cator (27) is on, channel indi-
cators (28) and LVL (29) will
not be displayed. Also, if
adjustments are done in a
mode where a certain channel
is not available, the adjust-
ment step for that channel is
skipped. For example, in Phan-
tom mode the center-channel
level cannot be adjusted since
Phantom does not have a cen-
ter channel. In stereo, neither
the center nor the surround
levels can be adjusted since
Stereo does not feature sur-
round speakers or a center
speaker.
A seventh press of the Level
button will exit the ESC 360
from its level-adjustment
mode.
11. Adjustment
These buttons are used in con-
junction with Test (8), Delay
(9), and Level (10) to increase
or decrease a setting.
12. Bass
Press (+) to increase the level
of low-frequency information.
Press (–) to decrease the level
of low-frequency information.
13. Treble
Press (+) to increase the level
of high-frequency information.
Press (–) to decrease the level
of high-frequency information.
14–17. Input
One of these four indicators
will illuminate, depending on
which input is selected.
18–21. Surround
One of these will illuminate,
depending on which surround
mode is chosen.
22. Dolby Digital
Indicates the presence of a
Dolby Digital-encoded AC-3
digital signal.
23. DTS
Indicates the presence of DTS
encoded digital signal.
24. Dolby Pro Logic
Illuminates when Dolby Pro
Logic decoding of a 2-channel
signal is taking place. This
indicator may be on by itself
(when analog inputs are used),
in conjunction with Dolby Dig-
ital (when using a digital
input where the AC-3 format
signal contains two channels
and needs to be decoded into
multichannel) or together with
PCM (when using a digital
input where 2-channel PCM-
format data is being decoded
into multichannel).
25. PCM
Illuminates when the signal
supplied through the selected
digital input is in PCM format.
26. Late Night
Illuminates when the Late
Night compression is selected.
-11-
27. Status-Bar Indicator
These LEDS show the relative
setting of volume, bass, treble,
speaker level and speaker
delay.
28. Speaker Indicator
Identifies the speaker that's
being adjusted. LS is Left Sur-
round, LF is Left Front, C is
Center, RF is Right Front, RS is
Right Surround, and SUB is
Subwoofer.
29. Level
Illuminates when the ESC 360
is in speaker-level adjustment
mode.
30. Delay
Illuminates when the ESC 360
is in speaker-delay adjustment
mode.
31. On
Indicates that the ESC 360 is
fully powered up.
32. Standby
Indicates that the ESC 360 is
plugged into an active wall
outlet and the master switch
on the back panel is in
On/Standby position, but the
unit is not powered on.
33. Mute
Illuminates when the mute
function is activated (the
ESC 360 will be on but will not
produce any sound).