QTek 2020 User Manual page 175

n Handle battery packs carefully
This product contains a Li-ion Polymer battery.
There is a risk of fire and burns if the battery
pack is handled improperly. Do not attempt to
open or service the battery pack.
Do not disassemble, crush, puncture, short
external contacts or circuits, dispose of in
fire or water, or expose a battery pack to
temperatures higher than 60¢XC (140¢XF).
Warning:
DANGER OF EXPLOSION
IF BATTERY IS INCORRECTLY
RE-PLACED. TO REDUCE RISK
OF FIRE OR BURNS, DO NOT
DISASSEMBLE, CRUSH, PUNCTURE,
SHORT EXTERNAL CONTACTS,
HEAT ABOVE 100
DISPOSE OF IN FIRE OR WATER.
REPLACE ONLY WITH SPECIFIED
BATTERIES. RECYCLE OR DISPOSE
OF USED BATTERIES ACCORDING
TO THE LOCAL RE-GULATIONS
OR REFERENCE GUIDE SUPPLIED
WITH YOUR PRODUCT.
c) Exposure to Radio
Frequency (RF) Signals
Your wireless phone is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limits for exposure
to radio frequency (RF) energy set by the
Federal Communications Commission of the
U.S. Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population.
The guidelines are based on the safety standards
previously set by both U.S. and international
standards bodies:
American National Standards Institute
n
(ANSI) IEEE. C95.1-1992
National Council on Radiation Protection
n
and Measurement (NCRP). Report 86. 1986
n
n
The exposure standard for wireless mobile
phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6W/kg *.
*In the U.S. and Canada, the SAR limit for mobile
phones used by the public is 1.6 watts/kg (W/kg)
averaged over one gram of tissue. The standard
incorporates a substantial margin of safety to give
additional protection for the public and to account
℃ (212℉),
OR
for any variations in.
d) SAR Information
THIS MODEL DEVICE MEETS THE GOVERN-
MENT'S REQUIREMENTS FOR EXPOSURE TO
RADIO WAVES.
Your wireless mobile GSM phone is a radio
transmitter and receiver. It is designed and
manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of
the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population.
The guidelines are based on the safety standards
previously set by both U.S. and international
standards bodies :
n
n
n
Pocket PC Phone User Manual
International Commission on Non-Ionizing
Radiation Protection (ICNIRP) 1996
Ministry of Health (Canada), Safety Code
6. The standards include a substantial safety
margin designed to assure the safety of all
persons, regardless of age and health.
American National Standards Institute
(ANSI) IEEE. C95.1-1992
National Council on Radiation Protection
and Measurement (NCRP). Report 86. 1986
International Commission on Non-Ionizing
Radiation Protection (ICNIRP) 1996
175