General Specifications And Instructions - Evcon DGAM056BDD Installation Instructions Manual

GENERAL SPECIFICATIONS AND INSTRUCTIONS

DLAS Series
60 1/2"
(on Sub--- Base)
1--- 7/8"
15--- 7/8"
2"
15--- 7/8"
IMPROPER INSTALLATION, ADJUSTMENT, SERVICE
OR MAINTENANCE CAN CAUSE INJURY OR PROPER-
TY DAMAGE.
PLEASE REFER TO ALL THE INSTRUCTIONS OF THIS
MANUAL FOR PROPER INSTALLATION PROCE-
DURES. IMPROPER INSTALLATION WILL VOID THE
WARRANTY.
THE FURNACE SHALL BE INSTALLED SO THE ELEC-
TRICAL COMPONENTS ARE PROTECTED FROM
WATER.
DO NOT TEST THE FUEL SYSTEM AT MORE THAN 14
INCHES WATER COLUMN AFTER FURNACE HAS
BEEN CONNECTED TO THE FUEL LINE. SUCH TEST-
ING MAY VOID THE WARRANTY.
ABOVE 14 INCHES WATER COLUMN MAY DAMAGE
24"
19--- 1/2"
23"
9--- 3/4"
10--- 5/8"
Figure 1 -- DLAS, DGAT, and DGAM Series Furnace Dimensions
ANY TEST RUN
DGAT & DGAM Series
WARNING
THE FURNACE CONTROL VALVE WHICH COULD
CAUSE AN EXPLOSION, FIRE, OR ASPHYXIATION.
These instructions are intended for the use of qualified indi-
viduals specially trained and experienced in installation of
this type of equipment and related system components.
Installation and service personnel are required by some
states to be licensed.
Persons not qualified shall not install this equipment or
interpret these instructions
The words "Shall" or "Must" indicate a requirement which is
essential to satisfactory and safe product performance.
The words "Should" or "May" indicate a recommendation
or advice which is not essential and not required but which
may be useful or helpful.
5
24"
19--- 1/2"
23"
9--- 3/4"
10--- 5/8"
76"
IMPORTANT NOTICE
.
NOTE