Advertisement
1) Balanced Microphone Input
The Microphone input accepts either a 6.35mm (¼") balanced jack or balanced XLR input. Before connecting any
source turn the volume knob anti-clockwise to the minimum setting. After connection with the audio source has been
made the volume knob should be adjusted carefully in small increments to avoid feedback.
2) Instrument/Microphone Input
The Instrument/Microphone input accepts either a 6.35mm (¼") unbalanced jack. Before connecting any source turn
the volume knob anti-clockwise to the minimum setting. After connection with the audio source has been made the
volume knob should be adjusted carefully in small increments to avoid feedback.
3) CD/Tape Input
The CD/Tape input accepts either a line level stereo audio signal via two phono sockets. Before connecting any
source turn the volume knob anti-clockwise to the minimum setting. After connection with the audio source has been
made the volume knob should be adjusted carefully in small increments. The volume control on this input is shared
with the iPod® dock – adjusting the level will alter the sound of both the CD/Tape and the iPod®.
4) Equalisation (EQ) Control
Adjustment for boosting or cutting the Bass, Mid or Treble frequencies. These alter the master output only, there is
no control for EQ control on each individual output. Turn anti-clockwise to cut (reduce) or clockwise to boost (add).
5) Master Volume Control
Overall volume control for the system. Turn the control anti-clockwise to reduce the sound level or clockwise to
increase. Care must be taken with the volume control as excessive volume can damage a person's hearing.
6) iPod® Charge
When switched to the ON position the iPod® will be charged from the internal battery. When switched to the OFF
position the iPod® will not be charged. Due to the changes made by Apple® to the configuration of the 30-pin
connector not all iPod's® will charge via this system.
7) Mains Inlet (IEC)
Insert the supplied mains cord into the mains inlet. The unit can operate from mains power or the internal battery.
The internal battery will only charge while the Power Switch (8) is in the OFF position. The inlet is fused with a T0.5A
250V 20x5mm mains fuse. Should the unit require a replacement fuse please ensure a replacement is fitted of the
same type and value. When charging the LED to the right of the mains inlet will illuminate.
8) Power Switch
On/Off control for the system. When the system is powered on the LED next to the Master Volume will illuminate.
9) Link Output
A mono line level output via a 6.35mm (¼") Jack for linking to another PA system or powered speaker. If using
another TREKKER i300 the LINK out of the master system should be connected to the CD/TAPE IN on the slave
system.
10) Battery Level Indicator
When switched on and fully charged all four LED's will illuminate, as the battery discharges the LED's will gradually
extinguish until only the red LOW LED is illumitaed, at this point the system requires recharging. Battery life will vary
depending upon the system volume and the ambient temperature.
11) Voltage Selector
The system can be operated from either a 240Vac or 110Vac mains supply. The PA System will be supplied with the
slide switch in the correct position for your local market. DO NOT alter the setting without first confirming the mains
supply available as the incorrect setting could damage the system.
4
Advertisement
