Branch Table - Scytek electronic G777 Product Manual

20. Data Bus Input Triggers. When enabled, the system will read all available triggers from the bypass
21. Data Bus Interface Mode. Selects between iData, Fortin, or Fortin RF kit bypass modules.
22. Starter Confirmation Chirps. When enabled system chirps before remote stater activated, when
disabled, no chirps will sound upon remote start.
23.Lock After Start. this dual program branch selects lock after start, and enables push to start.
Lock after Start ,when selected On, the doors will automatically lock after remote starting.
Push to Start enable, when selected, ??????????????
24.Lock After Shutdown. this dual program branch selects unlock after shutdown, and disables push to
start.
Unlock after Shutdown ,when selected On, the doors will automatically unlock after engine shutdown.
Push to Start disable, when selected , ??????????????
25.Unlock Before Start. when enabled, system will unlock doors prior attempting to start the engine.
26. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.
27.Automatic Start Mode. Selects between every two hours or every one hour for the automatic engine
starting feature.
28. Crank Time. Selects between normal, extended and super extended cranking time for tech-less mode
29. Engine Sense Mode. Selects between Monitor off or data bus??????????????
30.Engine Type. Selects between Gas engine or Diesel Engine
Gas Engine, sets the engine type for gasoline, remote starter will crank the engine
2 seconds after receiving remote start command.
Diesel Engine, sets the engine type for Diesel, remote starter will crank the engine
10 seconds after receiving remote start command.
31.Turbo Mode. When enabled ?????????????/
32. Factory Alarm Upgrade. When enabled system will arm and disarm using the factory remote
Page 20 - A777, A20, G777, G27
module. If disabled the system triggers must be hardwired.
Enabled with Validation, factory remote will disarm only when the Factory
disarm validation input is connected to the horn or parking lights. (this input
must be activated within a second upon unlock by the factory remote).