System Installation - Scytek electronic G777 Product Manual

1. Thoroughly read and become familiar with the installation instructions before beginning the
installation.
2. Review system contents:
Main Unit
1 One-Way 5-Button Remote Transmitter
1 Two-Way 5 Button LCD Transmitter
Siren
Shock Sensor
Harnesses
Receiver Antenna
14-Pin main harness
•
4-Pin shock sensor harness
•
3-Pin door lock harness
•
LED harness
•
Valet Switch harness
•
Receiver Harness
•
3. Verify with the owner, the mounting locations for all visible components, including the LED
and Override switch.
4. Verify with the owner, the optional features of the G777,G27,A777,A20 and the functions that
must be programmed during installation.
5. Inspect and perform a function test of all vehicle systems before and after the installation.
6. Always use a Volt / Ohm meter for testing vehicle circuits. Never use a test light.
7. Always look before drilling any holes or mounting self-tapping screws. Be sure fuel lines and
exterior wiring looms are clear as they are often close to the chassis and difficult to see.
8. Protect all wires running from the engine compartment to the interior of the vehicle by
covering with electrical tape and split loom tubing. Be sure to use a grommet when routing
wires through the firewall.
9. Properly fuse any additional accessories such as window modules, door lock actuators, etc.,
making sure to power them separate from the alarm module. This will ensure the functionality
of the security system in the event of an accessory failure.
Page 14 - G777,G27,A777,A20
S S y y s s t t e e m m I I n n s s t t a a l l l l a a t t i i o o n n