Replacing Microwave Oven Light - KitchenAid KHHC2090S Use & Care Manual

The microwave oven light is a 10W low-voltage halogen capsule
bulb. It will automatically come on when the door is opened and
when the microwave oven is operating. See "Assistance or
Service" section to reorder. You will need a TORX
screwdriver to remove the bulb cover.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Gently pull vent screen rings and lift the screen off the
exhaust vent at the top of the microwave oven.
If using recirculating exhaust venting, skip Step 3.
A
A. Vent screen
B. Rings
C. Bulb cover (under screen)
3. For wall or roof venting, remove the vent deflector by
removing the mounting screws (1 from each end), and lifting
out the vent deflector.
A
A. Bulb cover
B. Vent deflector
C. Vent deflector mounting screws (2)
†®TORX is a registered trademark of Textron Innovations Inc.

Replacing Microwave Oven Light

®†
T10
B C
B C
4. Remove the bulb cover mounting screw, then lift cover.
A. Bulb cover mounting screw
5. Remove the burned-out bulb by squeezing the wire clip
together, pulling to the right and lifting.
6. Replace bulb, using tissue or wearing clean cotton gloves to
handle bulb. Do not touch bulb with bare fingers.
7. Close bulb cover, and fasten with screw.
If using recirculating exhaust venting, skip Step 8.
8. For wall or roof venting, replace the vent deflector removed in
Step 3.
9. Replace vent screen.
10. Plug in microwave oven or reconnect power.
A
33