Event Status; Figure 43 ─ Event Status Setup Screen - ADT 4-channel DVR User Manual

Hide thumbs Also See for 4-channel DVR:
Table of Contents

Advertisement

User's Manual
Highlight the Notify box beside the desired event (System, Boot Up, Restart, Shutdown, Check Recording, Check
Alarm-In, Disk Almost Full, Disk Full, Disk Bad, Disk Temperature, Disk S.M.A.R.T., Disk Config Change or
Fan Error), and press the
the
button. You can toggle the individual items On and Off by highlighting that item and pressing the
Highlight OK and press the
NOTE: Mail notify is the only option available for the System event.
NOTE: For the Notify action to work, the DVR should be registered in the RAS (Remote Administration System).

Event Status

Highlight Event Status in the Event menu and press the
Figure 43 ─ Event Status setup screen.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of disk usage reaches
the Disk Almost Full percentage you made in the System Event setup screen on the Event menu. Disk Full will be
highlighted when the DVR is not in the Recycle mode and all available storage space has been used.
Fan Error will be highlighted when the cooling fan to the left of the power cord on the rear panel is not working for
more than four seconds.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section for details.
30
button. You can toggle the entire list On and Off by highlighting Notification and pressing
button to accept your changes.
button. The Event Status setup screen appears.
The Event Status screen displays the status of the DVR's
systems and inputs. Events will be highlighted, and related
channels or events will flicker for five seconds when detected.
Alarm-In, Motion and Video Loss will be highlighted when
each event is detected based on the settings you made in the
Alarm-In, Motion Detection and Video Loss setup screen on
the Event menu.
Check Alarm-In and Check Recording will be highlighted
when each event is detected based on the settings you made
in the System Event setup screen on the Event menu.
button.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents