ADT 4-channel DVR User Manual page 34

User's Manual
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box under the
Zone heading, and press the
Press the button to display the menu screen. The menu on the setup screen has the following functions:
Select ─ Activates highlighted blocks to detect motion.
Clear ─ Deactivates highlighted blocks so that they will not detect motion.
Reverse ─ Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All ─ Activates all blocks to detect motion.
Clear All ─ Deactivates all blocks so that they will not detect motion.
Reverse All ─ Activates inactive blocks and deactivates active blocks.
OK ─ Accepts changes and closes Zone setup.
Cancel ─ Exits Zone setup without saving changes.
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in the motion viewing
mode, any detected motion within the zone will be displayed in red.
You can control excessive event logging and remote notification of motions detected after the motion dwell time by
adjusting the motion ignoring dwell intervals. Highlight the box beside Motion Ignoring Interval and press the
button. A list of intervals ranging from 1 to 5 seconds or Never appears. The DVR will not log and notify motion
events occurred during the preset interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring function.
Highlighting the Daytime Setup box and pressing the
Highlight the Actions tab, and the Motion Detection Actions setup screen
26
Highlighting the box under the Sensitivity heading and pressing the
you to adjust the DVR's sensitivity to motion for Daytime and Nighttime independently.
There are five settings with 1 being the least sensitive and 5 being the most sensitive.
button. The Motion Detection Zone screen displays.
The Motion Detection Zone screen is laid over the video for the selected
camera. You can set up motion detection zones by selecting or clearing
blocks.
NOTE: You can set up motion zones one block at a time in groups
of 4 individual block groups A block group is positioned within the
image area using the Up and Down arrow buttons, and individual
blocks within the block groups are selected or cleared using the camera
buttons.
You can adjust the minimum number of detection blocks that must be activated to trigger
a motion alarm. Highlighting the box under the Min. Blocks heading and pressing the
button allow you to adjust the minimum number of detection blocks for Daytime and
Nighttime independently. Smaller numbers provide greater sensitivity because fewer
detection blocks must be activated.
Highlight the box beside Daytime and press the
arrow buttons to set the Daytime range. The DVR will consider the remaining
time range as the Nighttime.
button allows you to set up the Daytime range.
appears.
button allows
button. Use the Up and Down