Assembly And Adjustments - DeWalt D28090 Instruction Manual

FIG. 1
DESCRIPTION
(FIG. 1)
WARNING: Never
B
modify the power tool or
any part of it. Damage or
personal injury could result.
A. On/off switch
B. Spindle lock
C. Guard
D. Side handle
INTENDED USE
Your angle grinder
has been designed for
professional grinding and
cutting applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
DO NOT use grinding wheels other than center depressed wheels
and flap-disk.
This heavy-duty angle grinder is a professional power tool. DO NOT
let children come into contact with the tool. Supervision is required
when inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories.
WARNING: Prior to assembly and adjustment, ALWAYS unplug
tool.
WARNING: Never use the tool without the guard in place.
Mounting and Removing the Guard
(Fig. 2)
A
WARNING: Turn off
and unplug the tool
before making
D
adjustments or removing
or installing attachments
or accessories. Before
reconnecting the
depress and release the
paddle switch to ensure
C
that the tool is off.
1. Place the angle grinder
on a table, spindle up.
2. Align the lugs (F) with
the notches (G).
3. Press the guard down
and rotate it to the
required position.
4. Securely tighten the screw (H).
5. To remove the guard, slacken the screw.
Fitting and Removing a Grinding or
Cutting Disc (Fig. 3A, 3B)
1. Place the tool on a table, guard up.
2. Fit the inner flange (I) correctly onto the spindle (J) (fig. 3A).
3. Place the disc (K) on the flange (I). When fitting a disc with a raised
center, make sure that the raised center (L) is facing the flange (I).
4. Screw the outer flange (M) onto the spindle (J) (fig. 3B):
– the ring on the flange (M) must face towards the disc when
fitting a grinding disc (K);
30
FIG. 2
any
tool,
H
G
C
F
G