Safety Instructions For Battery Packs; Minimum Gauge For Cord Sets - Craftsman 16496 Bolt-On Operator's Manual

20v max power unit & drill attachment
Hide thumbs Also See for 16496 Bolt-On:
Table of Contents

Advertisement

Available languages

Available languages

volts
120V
240V
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
Than Than
0 -
6 -
10 -
12 -
• Do not place any object on top of charger or place the charger on a soft surface that might
block the ventilation slots and result in excessive internal heat. Place the charger in a
position away from any heat source. The charger is ventilated through slots in the top and the
bottom of the housing.
• Do not mount charger on wall or permanently affix charger to any surface. The charger is
intended to use on a flat, stable surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug — have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged
in any way. Take it to an authorized service center.
• Do not disassemble charger; take it to an authorized service center when service or repair is
required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk
of electric shock. Removing the battery pack will not reduce this risk.
• NeveR attempt to connect 2 chargers together.
• the charger is designed to operate on standard household electrical power
(120 volts). Do not attempt to use it on any other voltage.
IMPORtANt SAfetY INStRUCtION fOR BAtteRY PACkS
WARNING:
For safe operation, read this manual and manuals originally supplied with tool
before using the charger.
The battery pack is not fully charged out of the carton. Before using the battery pack and charger,
read the safety instructions below. Then follow charging procedures outlined.
• Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The
battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.
• Do not charge or use battery in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.
• If battery contents come into contact with the skin, immediately wash area with mild soap
and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until
irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is
composed of a mixture of liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If
symptoms persist, seek medical attention.
WARNING:
Burn hazard. Battery liquid may be flammable if exposed to spark or flame.
• Charge the battery packs only in Craftsman
• DO NOt splash or immerse in water or other liquids. This may cause premature cell failure.
• Do not store or use the tool and battery pack in locations where the temperature may reach
or exceed 105°f (40˚C) (such as outside sheds or metal buildings in summer).

Minimum Gauge for Cord Sets

total length of Cord in feet
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
51-100
American Wire Gauge
6
18
16
10
18
16
12
16
16
16
14
12
SAve theSe INStRUCtIONS
ReAD All INStRUCtIONS
51-100
101-150
101-200
201-300
16
14
14
Not Recommended
chargers.
®
6
14
12
12

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents