Loading The Tool; Guide Rod Installation - Bostitch F21PL Operation And Maintenance Manual

FSeries_166762RJ_BOS_FSeries_MAN_CC:FSeries_166762RJ_BOS_FSeries_MAN_CC 2013/3/6 上午10:02 Page 6
LOADING THE F SERIES TOOLS
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply
is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
F21PL, F21PL-2, F28WW, F33PT, F33PTSM
1. Open the magazine:
Pull pusher back to
engage the latch.
NOTE: Use only nails recommended for use in STANLEY-BOSTITCH Framing nailers or nails which meet the
STANLEY-BOSTITCH specifications.
When installing metal connectors with the F21PL, F21PL2, F33PT or F33PTSM: use only one
stick of metal connector nails at a time.
Never use contact trigger (black trigger) with metal connector attachment. Only use
sequential trigger (gray trigger) with metal connector attachment. Refer to trigger
conversion instruction included in the kit.
When installing Metal Connectors, use ONLY STANLEY-BOSTITCH Heat Treated Metal
Connector Nails.
Never use rafter hook to hang tool from body, clothing or belt.
GUIDE ROD INSTALLATION AND REMOVAL F21PL, F21PL-2, F33PT, F33PTSM TOOLS:
Fig. 1
F
R
2. Load Nails: Hold nailer down
with magazine tilted downward.
Insert stick of nails
GUIDE ROD
PULL HERE AND ROTATE
COVER TO OPEN
Fig. 3
INSTALL GUIDE ROD THRU HERE TOP HOLE
FOR .113" TO .131" SHANK NAILS
ROTATE COVER BACK TO CLOSE.
COVER ROTATED OPEN
INSTALL GUIDE ROD THRU HERE BOTTOM HOLE
FOR STORAGE ALONG OUTSIDE OF MAGAZINE
FOR .131" TO .162" SHANK NAILS
ROTATE COVER BACK TO CLOSE.
3. Close Magazine: Release pusher by
first pulling back on the pusher and then
pressing the pusher release tab. Slide
pusher against nails.
Fig. 2
ACCESS WINDOWS FOR INSTALLATION
AND REMOVAL OF GUIDE ROD.
ROTATE COVER OPEN TO
INSTALL OR REMOVE
GUIDE ROD.
INSTALL OR REMOVE
GUIDE ROD THRU
REAR OF MAGAZINE.
GUIDE ROD
STORAGE CHANNEL
6