Installation
Preparing Work for Installation
Open panel front
1. Pull the upper part of the front panel.
2. Lift up the panel.
3. To detach the front panel, remove the two screws at the lower part.
4. Detach the front panel from the body.
5. To detach the panel, disconnect the connector at the upper part.
Cover pipe and cover side remove
1. Please remove the screw of the center tuning
cover.
2. Pull up the side cover of desired connecting
direction, then cover side is separated.
3. Pick the pipe hole of the side cover.
CAUTION: After removing the
pipe hole, cut the burr for safety.
When making pipe path through rear
NOTICE
wall, you don't need to pick the pipe hole.
Drain hose junction
1. Remove the rubber stopple in the desired
drain direction.
2. Insert drain hose into the handle of drain pan,
and join drain hose and connecting hose
according to the figure by.
14 Room Air Conditioner
Pipe hole
Side cover
Adhesive
Connecting
part
Drain
hose
Panel Front
Connector
Only the
Only the
desired direction
desired direction
rubber cap