Yamaha YZF-R1(P) 2002 Service Information page 35

AK Pass the filter of throttle body
through the hole of rubber
baffle and release it under the
ignition coil plate.
AL Route the sub lead coupler be-
hind the ignition coil.
AM Pass the cam shaft position
sensor lead through the hole
of COVER 1 and connect it.
AN After branching the harness,
clamp each lead of the (+) lead
junction, starting circuit cut-off
relay, atmosphere pressure
sensor, lean angle cut-off
switch flasher relay in the
lump. Do not clamp the
ALARM coupler lead.
30
CABLE ROUTING
AO Press the lead of the coupler
for ALARM in under the cou-
pler of ECU.
AP Pay attention not to allow the
lead to slack and get caught
after wiring when assembling
the side cover.
AQ Make sure to hook the har-
ness on the hook of battery
box.
AR Pick-up coil lead
(Should be wired in front of the
clamp.)
AS Neutral switch lead
(Should be wired in front of the
clamp.)
2-39
SPEC
AT Fasten the (+) lead junction
lead by hooking on the pawl of
the box battery.
AU Push the (–) lead coupler into
the down side of wire harness
clamp.
AV Pull in the lead to the position
inside the frame until the dif-
ferent color tape attached to
the lead is invisible outside the
frame bottom edge.