JVC LT-22DE72 Instructions Manual page 33

Connections to other equipment
Using an AV Amplifier with built-in digital surround
If you are using an AV Amplifier with built-in digital surround sound, you can enjoy various audio systems
including Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.
Rear of the unit
To DIGITAL AUDIO
COAXIAL OUT
Coaxial digital cable
(not supplied)
To Coaxial
Digital Audio Input
AV Amplifier with built-in digital surround
decoder as listed above
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
• Digital Audio Output terminal does not output the sounds from devices connected by HDMI.
To connect the TV to a PC (Personal Computer)
BEFORE YOU CONNECT THIS TV TO YOUR PC, CHANGE THE ADJUSTMENT OF YOUR PC'S
RESOLUTION AND REFRESH RATE (60 HZ).
Connect one end of a (male to male) VGA cable to the video cord of the computer and the other end to the VGA
connector PC MONITOR IN on the rear of the TV. Attach the connectors firmly with the screws on the plug. In
case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to
the AUDIO IN connector of the PC/DVI AUDIO IN jack of the TV. You can also connect the PC with HDMI cable.
If you use HDMI cable, you don't have to connect the audio cord. If you use DVI-to-HDMI cable, please connect
audio cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
Rear and left of the unit
To PC
To
MONITOR
IN
PC/DVI
AUDIO
IN
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
• When the PC connected to the HDMI terminal and 1920x1080 resolution (FHD) is selected, the top and
bottom, right and left edges of the picture may be hidden on all PICTURE SIZE. In this case, use the PC
MONITOR IN jack (VGA cable) is recommended to connect.
• When the PC's resolution is set to 1920 x 1080/60 Hz (FHD mode), a signal that differs from the FHD signal,
which has been confirmed operational on this TV, may appear depending on the PC used. In this case, "Auto
Adjust" or other Position Adjustment functions may fail to correct the image position.
To solve this problem, change the PC settings to select another resolution.
To HDMI/DVI IN
HDMI cable (not supplied)
VGA cable (not supplied)
Audio cord (not supplied)
Front
Speaker
(Left)
Surround
Speaker (Left)
Monitor Display modes
MODE Resolution Refresh rate
VGA
VGA
SVGA
XGA
WXGA 1280x768 60Hz
WXGA 1360x768 60Hz
SXGA
WXGA+ 1440x900 60Hz
FHD
To return to normal mode
Press INPUT SELECT again.
(continued)
Front
Speaker
Subwoofer
(Right)
TV
Center Speaker
Surround
Speaker
(Right)
640x480 60/ 72/ 75 Hz
720x400 70Hz
800x600 56/ 60/ 72/ 75 Hz
1024x768 60/ 70/ 75 Hz
1280x1024 60Hz
1920x1080 60Hz
33