Panel Controls And Terminals (Details); Rear Panel - Steinberg UR 824 Operation Manual

Panel Controls and
Terminals (Details)

Rear Panel

DC IN 16V
For connection to the AC power adaptor.
Grounding screw
For connection to a ground wire.
If you have a problem with hum or noise, use this
terminal to connect to ground. The noise may be
reduced.
USB2.0 (USB port)
For connection to a computer or iPad. Apple iPad
Camera Connection Kit or Lightning to USB
Camera Adapter are required when connecting
the UR824 with an iPad.
USB Port Precautions
NOTICE
Be sure to observe the following points when
connecting to the computer's USB interface.
Failing to do so may result in the computer
freezing or shutting down, as well as corruption
or even loss of data. If the device or computer
does freeze, restart the application or computer.
• Be sure to wake the computer from sleep/
suspended/stand by mode before making a
connection to the computer's USB port.
• Before turning on the power to the device,
connect the computer to the USB port.
• Before turning on/off the device or plugging/
unplugging the USB cable, quit any open
application software on the computer.
• When connecting or disconnecting the USB
cable, be sure to set all output level controls to
the minimum.
• Wait at least six seconds between connecting
or disconnecting the USB cable.
WCLK switch
Switches between IN and OUT for the upper
WCLK terminal.
WCLK IN (OUT)/OUT (BNC connector)

Panel Controls and Terminals (Details)

For connection to the device which transmits and
receives the word clock.
OPTICAL A/B IN/OUT (optical)
For connection to a digital audio device.
You can select the format of the OPTICAL A/B
between ADAT and S/PDIF. To select the format,
use the "Setup Window" (page 13) in the section
"dspMixFx UR824" or the "Settings Window"
(page 19) in the section "Dedicated Windows for
Cubase Series."
You can select the output signal of the OPTICAL
A/B OUT. To select the output signal, use the
"Setup Window" (page 13) in the section
"dspMixFx UR824" or the "Output Routing
Window" (page 18) in the section "Dedicated
Windows for Cubase Series."
LINE OUTPUT 1–8 (phone type,
balanced/unbalanced)
For connection to monitor speakers. When the
monitor speakers have a balanced input, connect
them with a balanced cable.
You can select the output signal of LINE OUTPUT
1–8. To select the output signal, use the "Setup
Window" (page 13) in the section "dspMixFx
UR824" or the "Output Routing Window" (page
18) in the section "Dedicated Windows for
Cubase Series."
MIC/LINE INPUT 3–8 (XLR/phone type,
balanced/unbalanced)
For connection to a microphone or digital
instrument.
UR824
Operation Manual 5