Signal Flow - Steinberg UR 824 Operation Manual

Signal Flow

The following chart indicates the signal flow in the device.
NOTE
•The controllers on the device, such as the HI-Z switch, INPUT GAIN knob, and OUTPUT LEVEL knob, are not
included in this chart.
•To configure each parameter, use the "dspMixFx UR824" (page 9) or "Dedicated Windows for Cubase Series"
(page 15).
• Please note that you cannot use the built-in Channel Strip (Ch. Strip) and Guitar Amp Classics when the sample rate is set
to 176.4 kHz or 192 kHz.
•Some parts of the following signal flow may differ depending on the routing settings in the device.
From From
MIC/LINE/ MIC/LINE
HI-Z 1 HI-Z 2
Effect Effect
(INS.FX) (INS.FX)
*1
Effect Effect
(MON.FX) (MON.FX)
Volume Volume
Pan Pan
REV-X select
REV-X REV-X
Send Send
Level Level
From From
OPTICAL OPTICAL
A IN 1 B IN 8
Effect Effect
(INS.FX) (INS.FX)
Effect Effect
(MON.FX) (MON.FX)
Volume Volume
Pan Pan
*2
REV-X
REV-X REV-X
Return
Send Send
Level Level Level
REV-X
LOOPBACK
Volume
Pan
MIX 1
MIX 2
MIX 3
MIX 4
REV-X REV-X REV-X
Return Return Return
Level Level Level
*3
Appendix
From DAW
output
OFF/ON
To DAW
input
To LINE
OUTPUT 1/2
To LINE
OUTPUT 7/8
To OPTICAL A
OUT 1/2
To OPTICAL B
OUT 7/8
To PHONES 1
To PHONES 2
Operation Manual
UR824
33